72Bow Stand

[eric-c]

Here is the tank sitting on the stand, as you can see I didn't deduct for the 1/4" plywood surface. However, after thinking it over, maybe subtracting 3/16" would be better than 1/4". The 3/16" will give you a little room to play with. And I would say only deduct for the side panels, the back is fine with the 1/4" gap. IMO.



Here is a close up of the molding on the top of the stand. I bullnosed both top and bottom.



And the bottom piece of molding I bullnosed just the top.

 

[JohnK]

Bump for an amazing build thread. (I just noticed it linked in an RC thread, don't think I followed when the thread was new, I missed out... )

 

[eric-c]

Thanks John! I tell you what, for anyone who is looking at doing something like this, the doors really suck! If I went to do it again I would not have them flush with the stand, it's to much work and it just never did come out right. I had to put a gasket around the door because you could see the light from the fuge. Just and FYI.