• ******* To read about the changes to the marketplace click here

afboundguy's 35 gallon and display fuge build!!!

SPS frags have not been fairing well which has prompted me to do a bunch of troubleshooting and I ended up dusting off the Hannah nitrate tester and my nitrates were around 60 :cautious:

Ended up doing a 48 and just started carbon dosing with vinegar this morning to help lower nitrates as well as lowered how much phyto I have been dosing to 210 ml vs 300 ml per day.

I know the wire management is a nightmare and that's on my list of things to do when I hook up the Hydros system that I really need to do sooner rather than later!
PXL_20260121_115515176.jpg
 
60 Nitrates are fine
PXL_20260103_025913193.PORTRAIT.ORIGINAL.jpg
 
I may or may not have overflowed a 5 gallon bucket for a few hours after I forgot to set a timer a few days ago... Prompted me to look into adding a float switch for when I make water and found this little beauty for $8 on Amazon that clips to the side of the bucket!
PXL_20260122_121058603.jpg
PXL_20260122_121102623.jpg

I may be heading somewhere to pick up a tank (shhhhhhh) and will be stopping by Home Depot to grab some brute trash cans to try and setup a water mixing station to alleviate this issue so I'll have fresh mixed SW and RODI on hand...
 
Carbon dosing has gone well so far. Nitrates seem to be in the 30-40 range instead of 60-70 after the first week so I bumped up the dosage for week two.

Big shout out to @Chris.Reef for helping me with some 3D prints while my printers are still offline. He graciously printed some Hydros cable management clips and these bad boys for mangroves!
PXL_20260129_180035283.jpg


The white egg crate wasn't really cutting it and some of the mangroves were dying off so I took the ones that weren't looking so well back in the mainly freshwater-brackish bucket to see if they'll recover and transported two from that bucket into the tank.

Before:
PXL_20260129_173826239.jpg


After:
PXL_20260129_180030917.jpg
PXL_20260129_180029243.jpg
 
Took a few minutes to create a walk through update video of the setup! I know I need wire management and a bit of tidying up!

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.
 
Been a bit under the weather for various reasons and trying not to totally lay around 24/7 so I spent a little time organizing the layout. Moved some stuff around and vacuumed and threw down a cheapo "waterproof" mat on top of the foam board. I know about the cords it's one of my next things to do!
PXL_20260131_165632525.jpg
PXL_20260131_165640200.jpg
 
Also installed a cheapo paper towel holder since it was annoying to not have a permanent home for it! It's the little things!
PXL_20260129_195838547.jpg
PXL_20260129_195857069.jpg
 
Back
Top