Right now I fill a 25gal Rubbermaid with RO and add in 1/2 cup of kalk and 1/3 cup of vinegar. This keeps my parameters in check. This is all good but every time the container runs dry, I have to unhook a few hoses and bring the container up stairs to clean out the kalk particles.
My questions are as follows.
~Can I pre mix a 1/2cup kalk and vinegar in a separate 5 gallon bucket and then siphon the (over saturated) clear mixture into my top off container? The container would already be full of water ( minus the amount to fill the mixing container).
I know 2tsp per gallon is saturated but i hate taking my system apart to wash it out every week. By doing this would I also eliminate any residual kalk powder from accumulating on the bottom of my top off container?
I just tried topping off with fresh water only and dripping 3tsp/gal kalk throughout the day; that cold not keep up with my demand.
I am all ears and welcome any comments or revisions to my thoughts.
Thank you,
J.
My questions are as follows.
~Can I pre mix a 1/2cup kalk and vinegar in a separate 5 gallon bucket and then siphon the (over saturated) clear mixture into my top off container? The container would already be full of water ( minus the amount to fill the mixing container).
I know 2tsp per gallon is saturated but i hate taking my system apart to wash it out every week. By doing this would I also eliminate any residual kalk powder from accumulating on the bottom of my top off container?
I just tried topping off with fresh water only and dripping 3tsp/gal kalk throughout the day; that cold not keep up with my demand.
I am all ears and welcome any comments or revisions to my thoughts.
Thank you,
J.