Got the rubber cut and built a little frame to help contain any potential spill. Just ordered garage floor tiles that should be here Monday. Once those are in and I get the baseboard put on top, I’ll finish plumbing the ejector pump and build my stands!
-
******* To read about the changes to the marketplace click here
Keith’s 50 gallon low boy fish room
- Thread starter dlux5life
- Start date
I need to get a drip tray and use that type of garage floor tile in my setup!
Floor is down and sink permanently installed. No leaks for the win!!! The pan should hold about 50 gallons of water before I get concerned. I’ll get some water detection sensors so I should be able to address things before they get to that point.
Tomorrow is trim and starting to build the stand. Perhaps a shelf or two above the sink for testing supplies.
Tomorrow is trim and starting to build the stand. Perhaps a shelf or two above the sink for testing supplies.
Tank stand built and frag tank put in place. Tighter squeeze than I had anticipated, though I knew it would be tight. Stand may be a little high, but I’d prefer working height in the fuge below (yet to be put in). Gave myself a foot there, pushing the frag tank to about 40”.
Tight to the left where my mixing station is going to be as well. Tight all around, but better than trying to fit all this under a stand!! Once all the tanks are in place, I’ll likely wrap that stand in Azek, or something similar.
Tight to the left where my mixing station is going to be as well. Tight all around, but better than trying to fit all this under a stand!! Once all the tanks are in place, I’ll likely wrap that stand in Azek, or something similar.
