-
******* To read about the changes to the marketplace click here
unable to keep sps.
- Thread starter johnnyb
- Start date
OP
OP
johnnyb
Non-member
I believe that is correct. I have 4 of those. they were added after the problem started. they are far away from most of the corals you can see the dead bonsai next to the toadstool. in that pic. that bonsai had died before I bought the toad stool. I just havent pulled the dead stuff out because someone coming by said leave it he wanted to see.
Bobbofin
Non-member
Great post. I have had problems with SPS, LPS and softies in the past. An ultra clean tank favors SPS. A tank with a little dirtier water favors softies (zoas, leathers, etc). It can be a tough balance especially with leathers and SPS. I don't recommend it. Zoas and LPS along with SPS seem to do fine. if the water is super clean the SPS seem to grow better. If the water is a little bit less super clean the LPS and zoas seem to do better. The SPS, LPS and zoas all seem to still grow but at different rates due to the water quality. Leathers really seem to screw things up IMO and experience as far as SPS. I highly recommend not having leathers and SPS corals together due to the toxins that leather put out.
Oh, OK. The tyree toadstools shouldn't be of any unusual concern then.
OP
OP
johnnyb
Non-member
Added a bunch of charcoal and doing 30 gallon water changes everyother day for another week. I did pick up a birds eat the other day and a war corral frag. Haven't seen any signs of problems yet. One thing to note my alk is creeping up it was at 10.6 the other day before a water change. I will be retesting again tonite. May turn off the calcium reactor for a bit till the alk comes down. I am also adding my 55 gallon tank to the system this week and hope to swap out my Rubbermaid sump for a larger one. I may move the leathers to the 55 so I can put charcoal right at the overflow and isolate the water coming from the leathers. Plus adding this and swapping the dump will prevent the 2 gallon over flow I have when I lose power and add more water for stability and filtration. I don't have a picture but will try and get one today but I had something strange happen to a green slimmer I bought. One half turned completely white the other half seems ok. Not like separate branches but right down the middle of a branch. I will get a pic it's strange
What kind of Carbon you're using?
borderreef
Non-member
If I missed this somewhere, forgive me, it's a long thread. Did you dip your corals before introducing them?
OP
OP
johnnyb
Non-member
so these are not very good pictures but if you can see the slimer is almost perfectly white on one side. the blue picture its hard to tell what you are looking at but you can see the difference between the 2 sides. this is placed about half way down the tank just off to the side of a hydra 26 light the white part is facing away from the light but not completely. its like half of the white and half of the green face away from the light. it is about 14 inches from a fan that is directed above the coral so it gets flow but not direct flow. the other side seems fine but that may change quickly.
looking at your water volume of 2 tanks, refug, and sump....looks like +/-354 gallons. Looking at your coral livestock you listed at the beginning of the thread... it doesn't seem like much for that volume of water, do you really need a calcium reactor? I know nothing about CR as I only have ever dosed 2 part..
Seeing as that alk is creeping up again. Perhaps the issue is in fact the alk instability. Unless of course you have mass amounts of LPS kicking around in there that I may have missed reading through the thread
Seeing as that alk is creeping up again. Perhaps the issue is in fact the alk instability. Unless of course you have mass amounts of LPS kicking around in there that I may have missed reading through the thread
