-
******* To read about the changes to the marketplace click here
Crib's 210g Build
- Thread starter Crib
- Start date
Aquaman_68
too many gadgets to fail
glug glug glug...
OP
OP
Crib
Non-member
Pegging video
A quick 90 second video on pegging your rock, for future frag and colony placement
http://s215.photobucket.com/albums/cc176/salt_h2o/210g%20build/?action=view¤t=MVI_6466.flv
A quick 90 second video on pegging your rock, for future frag and colony placement
http://s215.photobucket.com/albums/cc176/salt_h2o/210g%20build/?action=view¤t=MVI_6466.flv
triggerhappy
Non-member
Might be a stupid question, but how did you attach the rods to the acrylic base?
OP
OP
Crib
Non-member
Hi Chris
No stupid question..
I took a 2x2" square piece of acrylic and used Weldon 4 and adhered the 2x2 square to the main base piece. Once adhered together that gave me about a 1/2' of dept, and I drilled almost all the way thru the 1/2" and applied more Weldon when placing the rod in the dept to cure before sliding the drilled rock thru to the base. Hope that helps..
OP
OP
Crib
Non-member
Chris, here is a picture the shows the additional piece of acrylic attached to the base then drill almost through
Attachments
OP
OP
Crib
Non-member
Found out the hard way that the sump did not fit in between the door opening of the tank stand.
When in Rome do as the Romans do. Drop it in.
Had to slide the 210g off to the side and then remove the center piece of wood to drop it in them replaced the brace.
Before and after
Thank You Nate for your help.....
When in Rome do as the Romans do. Drop it in.
Had to slide the 210g off to the side and then remove the center piece of wood to drop it in them replaced the brace.
Before and after
Thank You Nate for your help.....
