Hi There... I am building a DIY Break out box for my Apex. I plan on using 1/8 mono jacks to connect my float sensors (high and low).
I don't really have a use for the other 4 channels, so I though I would add some momentary SPST buttons, and use them to activate the Feed functions. Button 1 would be "Feed A", Button 2 would be "Feed B"- which would most likely be used for maintenance and turn the pumps off indefinitely. The third button I wanted to use as a "Cancel" button.
So basically something along the lines of:
if SW1 = CLOSED, then FEED A
if SW2 = CLOSED, then FEED B
if SW3 = CLOSED, then CANCEL FEED
So... how would I accomplish this?
I don't really have a use for the other 4 channels, so I though I would add some momentary SPST buttons, and use them to activate the Feed functions. Button 1 would be "Feed A", Button 2 would be "Feed B"- which would most likely be used for maintenance and turn the pumps off indefinitely. The third button I wanted to use as a "Cancel" button.
So basically something along the lines of:
if SW1 = CLOSED, then FEED A
if SW2 = CLOSED, then FEED B
if SW3 = CLOSED, then CANCEL FEED
So... how would I accomplish this?